Rushmore 2 Flute Micrograin Solid Carbide Single End Mill, 3/4″ Size, 3/4″ Shank Dia.

• Square-Nose Single End Mills for Use on Ferrous Non-Ferrous Workpieces.
• These straight shank single-end mills are offered with a two-flute spiral design with a lower 30-degree helix angle.
• It goes on to improve machining stability at high speeds.
• The center-cutting design has cutting teeth at the end of the tool, thus fed into the workpiece like a drill bit.
• Shank diameter tolerance is -0.0000 inch to -0.0005 inch.
• Helix Angle: 0
• Center Cutting: Yes
• Cutting Direction: Right Hand
• Workpiece Material Range: Steel, Stainless Steel, High-Temp Exotic Alloys, Non-Ferrous, Cast Iron, Hard Materials, Plastics

For More Rushmore 2 Flute Micrograin Solid Carbide Single End MillsClick Here